RC-Stadium.com

[RC-Stadium.com]

Here is my FLM Rustler VXL powered by one Lipo MaxAmps 11.1v 5000 mah and/or one Lipo Maxamps 11.1v 8000mah

Here is the list of hopup parts:

• Kit FLM (chassis tranny extended A-Arms)
  
• Revo shocks
  
• Front jato spring shock
  
• Tower Hobbies TS-170 Servo
  
• Ball bearing in bell crank
  
• All ball bearing are ceramic from Acer Racing
  
• Revo wing
  
• Mix of HPI and duratrax wing mount
  
• All star Wheel with Anaconda Tires
  
• HPI battery Mount
  
• GWS PG-03 gyro
  
• 2 fans one on the esc, one on the motor

Some photos:







Ton control this car, I'm using a Spektrum DX3R

[Riko]

hi!

I just wanted to know if you have to do some adjustment or use other parts etc to fit the E revo shocks on the Rustler?

thanx!
Riko

[RC-Stadium.com]

Hi,

No, no other parts. But for the front the spring or the oil is a little too hard for the rustler. The rear are really good.

[Riko]

Hi,

No, no other parts. But for the front the spring or the oil is a little too hard for the rustler. The rear are really good.

and did you do anything to fix the front?

[RC-Stadium.com]

No just adding one washer but no more things to do.

[Riko]

and what are the spring rates you used on the shocks front and rear?

I seem to see green for the front wich is 3.5 rate and blue for the rear wich is 5.9, is this correct?

you told me the front was a bit to hard still...so what would you recommend me? I also wich to use the Rustler for onroad racing only

[RC-Stadium.com]

For the front, I'm using the white spring. I think I have too change oil and make bigger hole in the piston.

[Riko]

I have a question about the suspension arms

are they the extended version front and rear?


if yess, what kind of turnbuckles did you use (toe and camber) did you use the stock ones or did you get ones from lunsford or did you use the one from a Jato?
because normally the stock normal lenght turnbuckles are to short for the extended FLM arms...

thx,
Erik

[Riko]

have a second question

what kind of rear arm mounts did you use, 1° or 4°?
because it seems you have high rear Toe In....


thx

[Riko]

reply??